Provide air traffic control services in the Pacific ICAO Region with the procedures and minima contained in this section except when noted otherwise.
Provide vertical separation in accordance with Chapter 4, Section 5, except when aircraft operate within airspace where composite separation and procedures are authorized, apply the minima specified in paragraph 8-9-5, Composite Separation Minima.
Provide longitudinal separation between aircraft as follows:
a. Between all aircraft, 15 minutes; or
b. Between turbojet aircraft provided the Mach number technique
is applied in accordance with paragraph 8-3-3:
1. 10 minutes; or
2. Between 9 and 5 minutes provided:
(a) It is possible to ensure by radar or other approved
means that the required time interval will exist at the common point from
which the aircraft either follow the same track or continuously diverging
tracks; and
(b) The preceding aircraft is maintaining a greater Mach
number than the following aircraft in accordance with the following table:
(1) 9 minutes if the preceding aircraft is Mach
0.02 faster than the following aircraft.
(2) 8 minutes if the preceding aircraft is Mach
0.03 faster than the following aircraft.
(3) 7 minutes if the preceding aircraft is Mach
0.04 faster than the following aircraft.
(4) 6 minutes if the preceding aircraft is Mach
0.05 faster than the following aircraft.
(5) 5 minutes if the preceding aircraft is Mach
0.06 faster than the following aircraft.
Provide lateral separation by one of the following:
a. Clear aircraft on different flight paths whose route widths
or protected airspace do not overlap.
b. When aircraft operate within airspace where composite separation
and procedures are authorized, apply the minimum specified in FAAO 7110.65,
paragraph 8-9-5, Composite Separation Minima.
c. When subparagraphs a or b are not applicable, apply 100 NM
between aircraft.
8-9-5 Composite Separation Minima
Provide composite separation within the Central East Pacific (CEP)
and North Pacific (NOPAC) composite route systems and where designated
by facility directive in the Pacific Organized Track System (PACOTS) at
and above FL 290 as follows:
a. 1,000 feet vertical separation; and
b. 50 NM lateral separation.
8-9-6 Composite Separation Altitude Assignment
a. Aircraft operating at or above FL 300 in a composite route
system may be cleared at even flight levels. Additionally, aircraft may
be cleared at even flight levels while joining, crossing, or leaving a
composite route system provided such aircraft leaving the system are cleared
to an appropriate odd cardinal flight level when noncomposite vertical
or lateral separation is achieved.
b. Aircraft (operating at or above FL 300) leaving a composite
route system at an even cardinal flight level do not have to be assigned
an odd cardinal flight level provided:
1. The aircraft is being provided radar service; and
2. The aircraft will be cleared for descent and approach to
an airport within the facility's domestic FIR; and
3. There is an operational advantage.
c. Aircraft operating on unidirectional routes or traffic flows
may be assigned altitudes other than the appropriate altitude for direction
of flight provided that 2,000 feet vertical separation is maintained between
aircraft operating on the same route.
8-9-7 Composite Separation Application
Provide composite separation in the Central East Pacific (CEP)
and the North Pacific (NOPAC) composite route systems and where designated
by facility directive in the Pacific Organized Track System (PACOTS) as
follows:
a. Clear an aircraft to join an outer route of the composite
route system at other than the normal entry point provided:
1. Longitudinal or noncomposite vertical separation exists between
that aircraft and any other aircraft on that route; and
2. Composite separation exists between that aircraft and any
other aircraft on the next adjacent route.
b. Clear an aircraft to leave an outer route of the composite
route system at other than the normal exit point provided its course diverges
so that lateral spacing from the route system increases until noncomposite
separation exists between that aircraft and any other aircraft in the composite
route system.
c. Clear an aircraft to change from one route to an adjacent route
within the composite route system provided:
1. Longitudinal or noncomposite vertical separation is maintained
between that aircraft and any other aircraft on the route being vacated
until that aircraft is established on the route to which it is proceeding;
and
2. Longitudinal or noncomposite vertical separation exists between
that aircraft and any other aircraft on the route to which that aircraft
is proceeding; and
3. Composite separation exists between that aircraft and any
other aircraft on the next adjacent route.
d. Clear an aircraft to cross the composite route system provided
longitudinal or noncomposite vertical or lateral separation exists between
that aircraft and any other aircraft in the composite route system.
e. Clear aircraft to transition to or from the composite route
system from an Oceanic Transition Route (OTR) provided:
1. The OTR is charted on aeronautical charts; and
2. Composite separation is maintained between that aircraft
and any other aircraft within the composite route system; and
NOTE -
An aircraft is within the confines of a composite route system when
the aircraft joins or crosses the outer route of the composite route system
or passes a composite route entry point.
3. Composite separation is maintained between that aircraft and
any other aircraft on adjacent OTRs.
f. Clear an aircraft to change altitude on a route if noncomposite
separation exists between that aircraft and others operating on that route
regardless of other aircraft operating on adjacent routes in the system.
Pilot's discretion climbs and descents are not authorized when applying
composite separation.
NOTE -
Although composite separation is not applied between aircraft on different
tracks at FL 280 and FL 290, this paragraph applies to climbs and descents
between FL 280 and altitudes within the composite altitude stratum (FL
300 and above).
a. In the Pacific CTA, IFR flights may be cleared to climb and descend in VFR conditions only if the following conditions are met:
1. When requested by the pilot.
2. Between sunrise and sunset.
b. Apply the following when the flight is cleared.
1. If there is a possibility that VFR conditions may become
impractical, issue alternative instructions.
2. Issue traffic information to aircraft that are not separated
in accordance with the minima in this section.
8-9-9. Procedures for Weather Deviations and Other Contingencies in Oceanic Controlled Airspace.
{New-98-3 Added February 26, 1998}
Aircraft must request an ATC clearance to deviate. Since aircraft will not fly into known areas of weather, weather deviation requests should take priority over routine requests. If there is conflicting traffic and ATC is unable to establish standard separation, ATC shall:
{New-98-3 Added February 26, 1998}
a. Advise the pilot that standard separation cannot be applied;
{New-98-3 Added February 26, 1998}
b. If possible, suggest a course of action; and
{New-98-3 Added February 26, 1998}
NOTE -
ATC may suggest that the pilot climb or descend to a contingency
altitude (1,000 feet above or below that
assigned if operating above FL 290; 500 feet above or below
that assigned if operating at or below FL 290).
{New-98-3 Added February 26, 1998}
c. To the extent practical, provide traffic information for all affected aircraft.
{New-98-3 Added February 26, 1998}
PHRASEOLOGY -
STANDARD SEPARATION NOT AVAILABLE, DEVIATE AT PILOT'S DISCRETION;
SUGGEST
CLIMB (or descent) TO (appropriate altitude); TRAFFIC (position
and altitude); REPORT DEVIATION
COMPLETE.
{New-98-3 Added February 26, 1998}
d. The pilot will follow the advisory altitude when approximately 10 NM from track.
{New-98-3 Added February 26, 1998}
e. At the completion of the deviation, ATC shall establish standard separation as soon as practicable.
{New-98-3 Added February 26, 1998}
NOTE -
In the event that pilot/controller communications cannot be
established or a revised ATC clearance is not available,
pilots will follow the procedures outlined in the Aeronautical
Information Manual (AIM) and Chart
Supplements.