One generator now in use is the brushless type. It is more efficient because there are no brushes to wear down or to arc at high altitudes.

This generator consists of a pilot exciter, an exciter, and the main generator system. The necessity for brushes has been eliminated by utilizing an integral exciter with a rotating armature that has its ac output rectified for the main ac field, which is also of the rotating type. A brushless alternator is illustrated in figure 9-40.

The pilot exciter is an 8 pole, 8,000 rpm, 533 cps, ac generator. The pilot exciter field is mounted on the main generator rotor shaft and is connected in series with the main generator field (figure 9-40). The pilot exciter armature is mounted on the main generator stator. The ac output of the pilot exciter is supplied to the voltage regulator, where it is rectified and controlled, and is then impressed on the exciter field winding to furnish excitation for the generator.

The exciter is a small ac generator with its field mounted on the main generator stator and its 3 phase armature mounted on the generator rotor shaft. Included in the exciter field are permanent magnets mounted on the main generator stator between the exciter poles.

The exciter field resistance is temperature compensated by a thermistor. This aids regulation by keeping a nearly constant resistance at the regulator output terminals. The exciter output is rectified and impressed on the main generator field and the pilot exciter field. The exciter stator has a stabilizing field, which is used to improve stability and to prevent voltage regulator overcorrections for changes in generator output voltage.

The ac generator shown in figure 9-40 is a 6 pole, 8,000 rpm unit having a rating of 31.5 kilovolt amperes (KVA), 115/200 volts, 400 cps. This generator is 3 phase, 4 wire, wye connected with grounded neutrals. By using an integral ac exciter the necessity for brushes within the generator has been eliminated. The ac output of the rotating exciter armature is fed directly into the 3 phase, fullwave, rectifier bridge located inside the rotor shaft, which uses high temperature silicon rectifiers. The dc output from the rectifier bridge is fed to the main ac generator rotating field.

Voltage regulation is accomplished by varying the strength of the ac exciter stationary fields. Polarity reversals of the ac generator are eliminated and radio noise is minimized by the absence of the brushes. Any existing radio noise is further reduced by a noise filter mounted on the alternator.

The rotating pole structure of the generator is laminated from steel punchings, containing all six poles and a connecting hub section. This provides optimum magnetic and mechanical properties.

Some alternators are cooled by circulating oil through steel tubes. The oil used for cooling is supplied from the constant speed drive assembly. Oil flow between the constant speed drive and the generator is made possible by ports located in the flange connecting the generator and drive assemblies.

Voltage is built up by using permanent magnet interpoles in the exciter stator. The permanent magnets assure a voltage buildup, precluding the necessity of field flashing. The rotor of the alternator may be removed without causing loss of the alternator's residual magnetism.